Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Bathroom Silicone Sealant For Wash Basins: How To Reduce Water Penetration And Edge Adhesion Failure At Wall Joints
Problem | Why Can Water Still Enter Behind A Wash Basin Even When The Wall Joint Has Been Sealed?
The joint between a wash basin and wall is frequently exposed to splash water. Water from hand washing or countertop cleaning can flow toward the rear wall connection.
Small pinholes, corner discontinuities, or localized adhesion failure can allow water to enter behind the fixture.
The key issue is therefore not simply the amount of silicone applied, but whether the entire wall-side joint remains continuous.
Cause | Why Do Wet Substrates, Corner Gaps And Uneven Sealant Sections Increase Water Penetration Risk?
Sealant needs direct contact with both bonding surfaces. Residual water after cleaning can interfere with this interface.
Wash basin joints also frequently include 90-degree corners. If extrusion stops while the applicator changes direction, a small discontinuity can remain.
Vertical wall joints are additionally influenced by gravity, making sag resistance relevant.
Solution | How Can ≤3 mm Sag And Adhesion Data Support Wash Basin Wall-Joint Application?
995 has a specified sag value of ≤3 mm, providing a quantitative reference for vertical wall-side applications.
Its tensile adhesion is >0.4 MPa at 23°C and >0.6 MPa at -20°C under the specified test conditions.
Before application, wall and countertop bonding areas should be clean and dry. Horizontal and vertical sealant sections should connect continuously at corners.
Technical Data | Which 995 Properties Matter For Wash Basin Wall And Corner Joints?
|
Property |
Specification |
Application Relevance |
|---|---|---|
|
Sag |
≤3 mm |
Vertical corner reference |
|
Extrusion Rate |
≥150 mL/min |
Continuous application |
|
Tensile Adhesion at 23°C |
>0.4 MPa |
Room-temperature reference |
|
Tensile Adhesion at -20°C |
>0.6 MPa |
Low-temperature reference |
|
Tack-Free Time |
≤3 h |
Skin formation reference |
|
Application Temperature |
4–40°C |
Application range |
|
Cure Type |
Neutral Cure |
Product system |
|
Component |
One Component |
No field mixing required |
How It Works | How Should Horizontal And Vertical Beads Connect To Reduce Water Paths Behind A Wash Basin?
The rear wash basin seal often includes both horizontal and vertical sections.
If these sections terminate separately instead of connecting continuously, a small gap may remain at the corner.
They should therefore be treated as one connected sealing path rather than separate visible beads.
FAQ | Can 995 Be Applied Immediately After Washing A Bathroom Surface With Water?
Application should not proceed while the bonding surface is visibly wet or covered by a water film.
The substrate should be clean and dry before sealant application.