Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Curtain Wall Sealant: How to Reduce Leakage in Unitized Curtain Wall Installation
Why Does a Unitized Curtain Wall Still Leak After Installation?
In a unitized curtain wall installation, panel joints and connections between glass and aluminum frames are common water-penetration risk areas. On high-rise façades, these joints are exposed not only to rain but also to wind pressure, temperature fluctuations, and thermal movement between different building materials.
If the curtain wall sealant cannot continuously accommodate joint movement, repeated expansion and compression may lead to adhesion failure or cracking. Once the sealing path is interrupted, rainwater can penetrate through the joint.
Therefore, controlling curtain wall leakage requires more than basic waterproofing. Movement capability must also match the actual joint design.
Why Does Joint Movement Damage the Seal?
Unitized curtain walls combine glass, aluminum profiles, and connecting components with different thermal expansion characteristics. Temperature changes, building movement, and wind loads can cause repeated expansion and contraction of façade joints.
The sealant therefore operates through continuous cycles of extension, recovery, and compression. Improper joint dimensions, contaminated substrates, or insufficient movement capability can concentrate stress at the bonding interface and eventually cause joint failure.
For this reason, effective sealing depends on three factors: substrate preparation, joint geometry, and sealant movement capability.
Use a Weatherproof Curtain Wall Sealant with Movement Capability
378 High Performance Silicone Curtain Wall Weatherproof Sealant is a one-component, neutral-cure silicone sealant designed for weatherproof sealing of glass curtain walls, aluminum curtain walls, and building joints.
According to the supplied technical data, its movement capability is ±25%, allowing the cured sealant to accommodate repeated dimensional changes within properly designed façade joints.
The product information also specifies good extrusion and thixotropic properties within -40°C to +90°C and identifies the product under GB/T 14683 with a 25HM classification. During installation, bonding surfaces should remain clean, dry, and free from oil or contamination. Joint dimensions should be designed according to expected movement rather than simply increasing the amount of sealant applied.
Technical Data
|
Property |
378 Technical Data |
Engineering Relevance |
|
Cure System |
One-component, neutral cure |
Suitable for on-site curtain wall joint sealing |
|
Movement Capability |
±25% |
Accommodates repeated joint movement |
|
Tensile Strength |
≥1.50 MPa |
Provides measurable tensile-performance data |
|
Tack-Free Time |
≤3 h |
Supports application and curing control |
|
Temperature Description |
-40°C to +90°C |
Good extrusion and thixotropic properties within the stated range |
|
Standard / Classification |
GB/T 14683, 25HM |
Provides a technical reference for sealant selection |
How It Works
After curing, the curtain wall silicone sealant forms a continuous elastic sealing layer between adjacent façade materials. When unitized panels move because of temperature changes or wind loads, the sealant extends and compresses with the joint, helping prevent stress from concentrating at the joint edges.
The ±25% movement capability is an important selection parameter, but it does not mean the sealant can compensate for every joint design. Joint width and depth, expected movement, substrate adhesion, and application conditions must still be evaluated.
For unitized curtain wall projects, reducing leakage therefore depends on a complete system: appropriate sealant selection + correct joint design + proper substrate preparation, rather than waterproof performance alone.