Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Structural Glazing Silicone Sealant: How to Reduce Adhesion Failure in Glass Curtain Wall Installation
Problem | Why Is “Strong Adhesion” Alone Not Enough?
In glass curtain wall installation, structural glazing silicone sealant forms a structural bond between glass panels and framing materials such as aluminum profiles. The bonded joint may be exposed to wind loads, temperature-induced movement, and dimensional changes throughout service.
Insufficient bond strength, improper joint dimensions, or poor substrate preparation may result in localized debonding or adhesion failure. For this reason, structural silicone selection should consider tensile adhesion strength, elongation behavior, and adhesion failure performance, rather than initial tack alone.
Cause | What Causes Structural Bonding Failure?
Structural bonding problems do not always originate from insufficient sealant strength. Dust or oil on glass surfaces, incompatible aluminum finishes, and inadequate bonding dimensions can reduce the effective adhesion area.
Wind pressure and thermal movement also introduce continuous stress into curtain wall joints. A sealant with high strength but insufficient deformation capability may concentrate stress around joint edges. Therefore, bond strength and elongation performance should be evaluated together.
Solution | Select Structural Silicone Using Verifiable Data
398 Silicone Structural Sealant is a one-component, neutral-cure structural silicone designed for glass curtain walls, aluminum curtain walls, and various metal structural applications.
According to the supplied technical data, its tensile adhesion strength reaches 0.95 MPa at 23°C, while elongation at maximum strength reaches 145% and the recorded adhesion failure area is 0% under the corresponding test conditions.
The 0.95 MPa result provides measurable evidence of structural bonding performance under the specified test condition. The 145% elongation indicates deformation capability under tensile loading, while the 0% adhesion failure result provides additional information about interface bonding during the test.
For actual curtain wall projects, adhesion and compatibility tests should still be performed using the specified glass, aluminum profiles, coatings, and accessory materials. Structural joint dimensions should be calculated according to panel dimensions, design wind loads, and project requirements.
Technical Specifications
|
Property |
Requirement |
Typical Result |
|
Cure Type |
Neutral Cure |
Neutral Cure |
|
Components |
One Component |
One Component |
|
Sag |
≤3 mm |
0 mm |
|
Tack-Free Time |
≤3 h |
0.5 h |
|
Extrusion Rate |
≥120 mL/min |
≥490 mL/min |
|
Shore A Hardness |
20–60 |
42 |
|
Tensile Adhesion Strength at 23°C |
≥0.60 MPa |
0.95 MPa |
|
Elongation at Maximum Strength |
≥100% |
145% |
|
Adhesion Failure Area |
≤5% |
0% |
How It Works | How Does Structural Silicone Transfer Loads?
After curing, the structural silicone forms a continuous elastic bonding layer between the glass panel and curtain wall frame. When wind pressure acts on the glass surface, loads are transferred through the structural silicone joint to the aluminum framing and supporting system.
This requires both sufficient bond strength and the ability to maintain joint continuity when small relative movements occur between components. The one-component formula eliminates on-site component mixing, while the neutral-cure system is suitable for various common curtain wall substrates.
However, structural load-bearing performance should never be determined from the 0.95 MPa tensile adhesion value alone. Joint width, bonding depth, glass dimensions, design wind load, substrate type, surface treatment, and project-specific structural calculations must all be considered when designing a structural glazing system.