Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Why Do Window Sealant Joints Crack? Causes, Solutions & Technical Data for 338 Silicone Sealant
Problem | Why Can Sealant Joints Crack After Window Installation?
Perimeter sealant forms an important sealing interface between window frames and surrounding construction substrates. If the joint is incompletely filled, contains excessively thin sections, or is applied over contaminated surfaces, localized cracking or edge separation may develop.
The solution is therefore not simply to apply more sealant. Substrate preparation, joint dimensions, and bead continuity should be evaluated together.
Cause | How Does Application Quality Affect Joint Cracking?
Extrusion behavior affects the continuity of the applied bead. The specified extrusion requirement for 338 is ≥150 mL/min, while the measured result is ≥420 mL/min, providing quantitative evidence of application performance.
Joint dimensions also matter. The product information recommends an application thickness of generally ≥6 mm. This is a reference for avoiding excessively thin sections rather than an instruction to maximize sealant thickness.
Solution | How Can Proper Application Reduce Cracking Risk?
338 uses a one-component, neutral-cure silicone system, requiring no on-site component proportioning. Bonding surfaces should be cleaned of dust, oil, and moisture, with adhesion and compatibility checked on the actual substrates.
A sag value of ≤3 mm helps control bead geometry on vertical joints, while the measured 0.5 h skin-over time provides a practical reference for tooling.
Technical Data
|
Property |
Data |
Technical Relevance |
|---|---|---|
|
System |
One-component, neutral cure |
No on-site proportioning |
|
Extrusion Rate |
Measured ≥420 mL/min |
Supports continuous application |
|
Sag |
≤3 mm |
Supports vertical bead control |
|
Skin-Over Time |
Measured 0.5 h |
Reference for tooling |
|
Recommended Thickness |
Generally ≥6 mm |
Helps avoid thin sealant sections |
Application | Where Can the Sealant Be Used?
338 is intended for specified aluminum window installation, perimeter sealing, and general construction joints. Proper substrate preparation, continuous filling, and suitable joint dimensions are essential to joint quality.