Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Construction Silicone Sealant for Vertical Aluminum Window Joints: How ≤3 mm Sag Supports Bead Formation Control
Problem | Why Can Vertical Aluminum Window Beads Become Uneven?
Before curing, sealant on vertical window joints is affected by gravity. Excessive downward movement may produce thinner upper sections, accumulation below, or inconsistent bead geometry.
Cause | What Does Sag ≤3 mm Tell Us?
338 provides a sag value of ≤3 mm, giving a quantitative reference for vertical bead-shape retention.
It is more accurate to retain this value than to make an absolute “zero sag” claim. The product also provides good extrusion and thixotropic properties from −40°C to +40°C, but this range should not be rewritten as an unrestricted recommended application temperature.
Solution | How Should Sag Performance Be Used in Practice?
Control material output according to joint dimensions and maintain consistent gun movement. Aluminum surfaces should be clean, dry, and verified for adhesion and compatibility.
The measured extrusion rate of ≥420 mL/min describes extrusion behavior, while sag ≤3 mm describes vertical shape retention. These are related application parameters but should not be treated as the same property.
Technical Data
|
Property |
Data |
Meaning |
|---|---|---|
|
Sag |
≤3 mm |
Vertical bead control |
|
Extrusion |
Measured ≥420 mL/min |
Material output |
|
Extrusion/Thixotropic Range |
−40°C to +40°C |
Defined performance range |
|
Skin-Over |
Measured 0.5 h |
Tooling reference |
|
Cure System |
Neutral cure |
Cure chemistry |
FAQ
Does ≤3 mm mean absolutely zero sag?
No. The measured value should be retained without turning it into an absolute claim.
Does higher extrusion automatically cause more sag?
No direct conclusion can be made from these two values alone.