Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Sealant Debonding on Aluminum Frames? Surface Prep & Adhesion Verification Guide
Problem | Why Can Sealant Lose Adhesion on Aluminum Windows?
Edge lifting and localized debonding often originate at the interface between the sealant and aluminum substrate. Once this interface becomes discontinuous, it may create a potential path for water and air.
Seasonal installation also requires attention to extrusion and bead formation rather than relying only on a general adhesion claim.
Cause | What Can Weaken the Sealant-to-Aluminum Interface?
Oil, dust, moisture, and other contaminants can prevent sufficient contact with the actual aluminum surface. Surface preparation and adhesion verification are therefore important.
The 338 technical information states good extrusion and thixotropic behavior from −40°C to +40°C. This supports application-performance descriptions within the stated range, but does not mean unrestricted application under every condition.
Solution | What Should Be Controlled During Seasonal Installation?
The aluminum surface should be clean and dry, with adhesion and compatibility checked according to the actual surface finish.
The measured extrusion rate of ≥420 mL/min provides an application-performance reference, while sag ≤3 mm helps evaluate bead stability on vertical joints.
Technical Data
|
Property |
Data |
Relevance |
|---|---|---|
|
Cure Type |
Neutral cure |
Construction sealing system |
|
Component |
One-component |
No on-site mixing |
|
Extrusion/Thixotropic Range |
−40°C to +40°C |
Defined application-performance range |
|
Extrusion |
Measured ≥420 mL/min |
Continuous application reference |
|
Sag |
≤3 mm |
Vertical bead control |
|
Storage |
≤27°C |
Dry and shaded storage |
Application | How Should It Be Used on Aluminum Windows?
338 is intended for specified aluminum window installation and perimeter sealing. Actual surface condition and adhesion should be verified before full-scale application.