Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Problem | Why Can Sealant Beads Deform on Vertical Aluminum Window Joints?
Aluminum window systems contain many vertical perimeter joints. Before curing, insufficient bead stability can result in downward movement, uneven sealant sections, and difficult tooling around corners and termination points.
For this reason, surface smoothing alone cannot solve vertical-joint problems. Bead stability and joint continuity need to be controlled during application.
Cause | Why Is Sag an Important Parameter for Vertical Application?
Uncured silicone has flow characteristics, making thixotropic behavior particularly relevant on vertical joints. 338 Multi-Purpose Silicone Sealant has a sag value of ≤3 mm, providing a quantitative reference for bead-shape retention.
The product information also states good extrusion and thixotropic properties from −40°C to +40°C. This range describes these specific application properties and should not be interpreted as an unrestricted recommended site-application temperature.
Solution | How Can Vertical Window Joints Be Applied More Consistently?
Remove dust, oil, and moisture from aluminum and adjacent substrates before application, and verify adhesion and compatibility on the actual materials.
Maintain a consistent relationship between gun movement and sealant output. The measured extrusion rate of ≥420 mL/min provides quantitative evidence for extrusion behavior, while the measured skin-over time of 0.5 h can be used as a reference when planning tooling operations.
The recommended application thickness is generally ≥6 mm, but actual joint dimensions should follow the joint design rather than simply increasing sealant volume.
Technical Data
|
Property |
338 Data |
Relevance to Vertical Application |
|---|---|---|
|
Product System |
One-component, neutral cure |
No on-site proportioning |
|
Sag |
≤3 mm |
Vertical bead-shape reference |
|
Extrusion |
Measured ≥420 mL/min |
Continuous extrusion reference |
|
Skin-Over Time |
Measured 0.5 h |
Tooling-time reference |
|
Extrusion/Thixotropic Range |
−40°C to +40°C |
Defined application behavior |
|
Recommended Thickness |
Generally ≥6 mm |
Sealant-section reference |
FAQ | Common Questions About Vertical Aluminum Window Joints
Q1: Does sag ≤3 mm mean the sealant will never move?
No. It is a test value describing sag performance and should not be interpreted as zero movement under every site condition.
Q2: Does a higher extrusion rate automatically improve bead formation?
No. Extrusion and bead stability are different properties. Sag, application speed, and joint dimensions should also be considered.
Q3: Is adhesion testing unnecessary on aluminum frames?
No. Aluminum surface treatments can vary, so adhesion and compatibility should be verified on the actual substrate.