Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Window Silicone Sealant for Long Perimeter Joints: One-Component System for Continuous and Controlled Extrusion
Problem | Why Do Long Window Joints Develop Interrupted Sealant Beads?
Long perimeter joints require continuous application. If extrusion resistance, gun movement, and material output are poorly coordinated, the bead may become uneven or interrupted, particularly around corners and transitions.
The practical value of easy extrusion is therefore not simply faster output. It helps support a continuous and controllable sealant bead.
Cause | Why Is Extrusion Rate More Useful Than Saying “Easy to Apply”?
338 specifies an extrusion requirement of ≥150 mL/min, with a measured result of ≥420 mL/min.
This provides quantitative evidence of extrusion behavior. It should not, however, be converted into an unsupported percentage increase in installation efficiency or used as proof of waterproofing or adhesion strength.
Solution | How Should Extrusion Performance Be Used on Long Joints?
Plan the application path according to joint dimensions and clean all bonding surfaces. Minimize unnecessary interruptions and maintain continuity at corners.
The one-component system requires no on-site mixing. After application, the measured 0.5 h skin-over time provides a tooling reference, while sag ≤3 mm helps evaluate vertical sections.
Technical Data
|
Property |
Data |
Technical Meaning |
|---|---|---|
|
Extrusion Requirement |
≥150 mL/min |
Specified requirement |
|
Measured Extrusion |
≥420 mL/min |
Extrusion-performance evidence |
|
Sag |
≤3 mm |
Vertical bead control |
|
Skin-Over |
Measured 0.5 h |
Tooling reference |
|
Component |
One-component |
No on-site mixing |
|
Packaging |
260 mL / 590 mL |
Cartridge/sausage options |
FAQ | Common Questions About Continuous Application
Does ≥420 mL/min guarantee faster installation?
No. Actual application speed also depends on equipment, nozzle dimensions, joint geometry, and operator technique.
Can long beads be interrupted and simply patched later?
Unnecessary interruptions should be minimized, and transition points should be checked carefully.
Does smooth extrusion prove water resistance?
No. Extrusion behavior and final sealing performance are different technical considerations.