Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Silicone Sealant for Aluminum Window Frames: Neutral Cure Silicone for Joint Leakage Control and Continuous Sealing
Problem | Why Do Aluminum Window Frame Joints Develop Localized Water-Entry Points?
Aluminum window perimeters contain horizontal, vertical, corner, and connection joints. A single interruption or underfilled section can compromise joint continuity.
Cause | Why Is Surface Appearance Not Enough?
Effective sealing depends on both continuous filling and effective substrate contact. Dust, oil, moisture, and interrupted application can create weak points.
The measured extrusion rate of ≥420 mL/min provides an extrusion reference, while sag ≤3 mm supports vertical bead control.
Solution | How Can Continuous Sealing Be Improved?
Clean the aluminum bonding surface and verify adhesion and compatibility. Maintain continuity through corners and joint transitions.
A thickness of generally ≥6 mm is recommended, while the measured 0.5 h skin-over time provides a tooling reference. Extrusion and sag data describe application behavior, not a specific water-tightness rating.
Technical Data
|
Property |
Data |
Relevance |
|---|---|---|
|
Product Type |
Neutral cure silicone sealant |
Construction joint sealing |
|
Extrusion |
Measured ≥420 mL/min |
Continuous application |
|
Sag |
≤3 mm |
Vertical bead formation |
|
Skin-Over |
Measured 0.5 h |
Tooling reference |
|
Thickness |
Generally ≥6 mm |
Joint-section control |
FAQ
Does a high extrusion rate mean better waterproofing?
No. Extrusion describes application behavior, not water-tightness.
Should a leaking aluminum window simply be patched at the visible point?
Adjacent sections should also be checked for discontinuity, voids, or adhesion failure.