Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Construction Joint Sealant for Window Perimeters: Neutral Cure Silicone for Continuous Weather Sealing and Water-Entry Path Control
Problem | Why Can Aluminum Window Installation Be Affected by Multiple Application Steps?
Window perimeter sealing involves horizontal joints, vertical sections, corners, and termination points. If a material requires additional on-site component proportioning and mixing, the preparation process becomes more complex. Application efficiency should therefore consider material preparation, extrusion continuity, vertical bead formation, and tooling, rather than application speed alone.
Cause | Why Does a One-Component System Simplify Preparation?
338 Multi-Purpose Silicone Sealant uses a one-component, neutral-cure system, requiring no on-site component proportioning or mixing.
Its extrusion requirement is ≥150 mL/min, with a measured result of ≥420 mL/min, providing quantitative evidence of extrusion behavior. This data should not be converted into an unsupported percentage improvement in installation efficiency.
Solution | How Can Ready-to-Use Application Be Controlled on Site?
Check storage conditions and clean dust, oil, and moisture from the actual substrates before application. Adhesion and compatibility should also be verified.
The measured ≥420 mL/min extrusion rate provides a continuous-application reference, while sag ≤3 mm supports vertical bead control. The measured 0.5 h skin-over time can be used when planning tooling operations.
Technical Data
|
Property |
Data |
Application Relevance |
|---|---|---|
|
Component |
One-component |
No on-site proportioning |
|
Cure System |
Neutral cure |
Cure chemistry |
|
Extrusion |
Measured ≥420 mL/min |
Continuous application |
|
Sag |
≤3 mm |
Vertical bead control |
|
Skin-Over |
Measured 0.5 h |
Tooling reference |
|
Packaging |
260 mL / 590 mL |
Packaging options |
FAQ
Does one-component mean no preparation is required?
No. Surface cleaning, substrate verification, and joint preparation are still required.
Can ≥420 mL/min be presented as a specific productivity increase?
No. It is an extrusion-performance value, not a measured productivity percentage.