Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
One-Component UV-Curable Adhesive Sealant For Selective Application
Product Positioning and Intended Use
This one-component UV-curable adhesive sealant uses a urethane acrylate resin system. The supplied document identifies structural bonding and sealing applications in industrial and consumer electronic devices, particularly on plastic substrates.
Application using selective coating equipment or conventional manual spray equipment is documented. Settings for a particular machine must be established through application trials rather than inferred from the material description alone.
Problem | Why Check the Adhesive Layer When the Path Is Unchanged?
Electronic device assembly requires adhesive to reach the intended location while remaining within defined application boundaries. Operators also need to identify missed areas and local material accumulation.
An unchanged application path does not establish identical adhesive thickness on every part. Corners, path transitions and other locations with visible accumulation need examination before the assembly proceeds to curing.
Cause | Viscosity Does Not Directly Define Machine Settings
The document lists a viscosity of 10,000–20,000 cps at 10 rpm. It does not specify the measurement temperature or spindle.
This value provides an initial material reference, but cannot directly determine nozzle selection, delivery pressure or travel speed. It also does not establish non-sag behavior. Equipment suitability therefore depends on observing how the material is delivered and deposited under the proposed operating conditions.
Solution | Connect Application Settings with Measured Results
Run trials on the intended substrate. Record the nozzle, delivery settings, travel speed and resulting application pattern. Adjust one setting at a time so that changes in coverage can be traced to a specific adjustment.
Inspect the application boundary, continuity and local thickness. Use the adhesive’s fluorescence under UV light to support coverage inspection, then verify curing at the actual deposited thickness.
The documented curing depth of >120 μm does not justify unrestricted material buildup. Complete test conditions are not supplied, so areas with thicker deposits require assessment under the intended exposure conditions.
Technical Specifications
Property | Document Reference Value or Description | Source |
|---|---|---|
Product name | UV-curable adhesive sealant | Document description |
Resin and components | Urethane acrylate; one-component | Description and parameter table |
Appearance | Colorless, translucent liquid | Parameter table |
Viscosity | 10,000–20,000 cps at 10 rpm | Parameter table |
Density | 1.10 ± 0.05 g/cm³ | Parameter table |
Recommended curing conditions | LED, 365 nm; 500 mW/cm²; 10 s | Parameter table |
Application methods | Selective coating equipment or conventional manual spray equipment | Application instructions |
Intended use | Structural bonding and sealing of electronic devices, particularly plastic substrates | Document description |
Application | Electronic Assemblies with Defined Application Boundaries
The document supports electronic bonding and sealing using the stated application methods. Specific components, application areas and keep-out zones must be defined by the assembly requirements.
The use of selective coating equipment does not, by itself, classify this material as a printed circuit board conformal coating.
How to Choose | Check Material Delivery and UV Access Together
Equipment selection should address material delivery, deposit formation and access for curing light. A machine that deposits the adhesive successfully still requires a compatible curing arrangement.
The recommended 365 nm source, 500 mW/cm² intensity and 10-second exposure provide a curing-trial reference. They do not establish the cycle time of a complete production line.
FAQ | Can Solvent Be Added to Reduce Viscosity?
The document specifies no approved thinner or addition ratio. Do not establish a dilution recipe from this information. First check equipment compatibility, then obtain the supplier’s permitted adjustment procedure.