Quick Link
Quick Contact
Address
No. 1707, Industrial Road, Tangshan Town, Huantai County, Zibo City, Shandong Province
Tel
86-533-17860959591
Our Newsletter
Subscribe to our newsletter for discounts and more.
Silicone Sealant For Thermal Break Windows: How To Reduce Joint Cracking And Adhesion Failure Under Temperature Changes
Problem | Why Can Thermal Break Window Joints Look Normal After Installation But Develop Cracking Or Edge Separation After Seasonal Temperature Changes?
Thermal break window joints may appear normal immediately after installation but gradually develop cracking, edge separation, or localized sealing failure after exposure to summer heat and winter cold.
This should not automatically be interpreted as poor low-temperature resistance. A window system combines aluminum profiles, glass, thermal break components, and surrounding construction materials that can respond differently to temperature changes.
Cause | How Can Differential Material Movement And Locally Thin Sealant Increase Stress In Thermal Break Window Joints?
Aluminum, glass, and adjoining materials can expand and contract differently as temperature changes. If the joint geometry or sealant filling does not provide appropriate space for this movement, stress can become concentrated in localized areas.
Thin sealant sections, internal voids, and incomplete edge adhesion can become particularly vulnerable under repeated temperature changes.
Cold-weather installation can also introduce condensation. Moisture on the bonding surface may interfere with initial sealant-to-substrate contact.
Solution | How Should The -20°C Tensile Adhesion Data Be Used When Evaluating Thermal Break Window Sealing?
995 provides defined adhesion data at two test temperatures: >0.4 MPa at 23°C and >0.6 MPa at -20°C.
These values can be used to describe adhesion performance under the stated test conditions. They should not be extended into an unsupported claim that the joint will never crack under any temperature variation.
The specified application temperature is 4–40°C. Therefore, the -20°C result describes a performance test condition rather than an approved installation temperature.
Technical Data | Which 995 Properties Are Relevant To Thermal Break Windows Exposed To Seasonal Temperature Changes?
|
Property |
Specification |
Technical Meaning |
|---|---|---|
|
Tensile Adhesion at 23°C |
>0.4 MPa |
Room-temperature test condition |
|
Tensile Adhesion at -20°C |
>0.6 MPa |
Low-temperature test condition |
|
Application Temperature |
4–40°C |
Different from -20°C performance testing |
|
Sag |
≤3 mm |
Vertical application reference |
|
Extrusion Rate |
≥150 mL/min |
Continuous application reference |
|
Tack-Free Time |
≤3 h |
Surface skin formation reference |
|
Cure System |
Neutral Cure |
Neutral silicone system |
|
Component |
One Component |
No two-component mixing required |
How It Works | Why Does -20°C Tensile Adhesion Not Automatically Mean Low-Temperature Application Or Crack-Free Window Joints?
Tensile adhesion data describe performance measured under a defined test condition, while application temperature defines the conditions under which the material is intended to be installed.
The >0.6 MPa tensile adhesion value at -20°C provides a low-temperature performance reference, but the specified application temperature remains 4–40°C.
Joint cracking is also influenced by joint dimensions, substrate type, adhesion quality, and actual joint movement. One low-temperature adhesion value cannot independently predict long-term cracking behavior of the complete window system.
How To Choose | How Should Low-Temperature Performance, Application Temperature And Actual Profile Adhesion Be Evaluated For Thermal Break Windows?
First, review performance data with clearly stated test temperatures rather than relying only on general descriptions such as “high and low temperature resistance.”
Second, verify that the specified application temperature matches site conditions. Third, conduct adhesion testing using the actual thermal break aluminum profile and glass, especially when coated or specially treated surfaces are involved.